(Caution) Storage

Keep away from water and moisture; store in dark and cool place to avoid from film sticking.

Do NOT expose to sunlight, direct heat.

Do not stack them in multiple stages.

The film performance can be lowered if stored for long period of time.

(Caution) Installation guide

House film has different functions inside and outside, so be sure to install it so that the letters printed on the film surface can be seen correctly outside the house.

The thin film could get damage easily by sharp things or metals. Make sure to clean the work site and start a film covering.

Do not get the product wet, and store it in a cool and shaded place as there is a risk of film sticking when stored in a hot and humid place.

If new film is covered over the old film, it may cause oxidation. Install it after removing the old film completely.

When installing, apply the pad film to prevent damage from the pad spring.

Do not stretch the film on hot days as it will contract when cool and may weaken, and if it is too loose, it will cause wrinkles and deteriorate anti-dripping effect.

The angle of greenhouse ceiling must be over 25degree without winkle for smooth water sliding. Lanyard should be installed loosely to avoid winkle on the film.

User guide

After installation, the performances of Anti-drip, Anti-fog, Weatherability and heat retainablity are declined gradually depending on the usage of environment and time.

Proper maintenance for film effectiveness

Avoid installation during summer or just before summer starts, make sure to ventilate air sufficiently not to get the inner layer of the film wet (Anti-fog face).

Do not let pesticide get in contact with the film.

Greenhouse gradient angle must exceed 25degree and avoid moisture by mulching top of the soil.

The house film can get damaged often during installation of side window or ventilator. Proper installation must be taken to avoid film damage.

The thickness of above 0.06mm should be used as out layer film. It is recommended to replace the out layer film once a year for better cultivation by high transparency.

The transparency of the film could be different from batch to batch, storage condition (place, temperature, humidity and storage period)

The heat retainablity of the film depends on the type of material and thickness; insulation and heating devices must be used to maintain the appropriate temperature focultivation. Proper installation like fine finishing (no holes and gaps between outside and inside of greenhouse), greenhouse direction, and method of farming could make a big difference.

Notice about the performance of agricultural film

The agricultural film is designed to maximize the crop yield and minimize the damages from nature. The performance of the film could be limited by the current technology of the additives and installation place. In order to solve this problem, research is being conducted not only in our company but also worldwide, but we have not yet found a fundamental solution.

※ Please read cautions related to the agricultural film performance before installation.

(Caution) Anti-drip on the films is not guaranteed always.

What is Anti-drip? It is a feature that prevents the water droplets from forming on the film surface and let it flow on the surface. Inner and middle layer has anti-drip & other additives which reduce water forming inside of the greenhouse. The period of anti-drip effect is 50 to 75days (based on 0.06mm thick) depending on installation condition.

(Caution) Check list when anti-drip effect is hindered

When the film is contacted with the pesticides, the anti-drip additive (surfactant) at the inner layer film becomes neutralized and hindered.

Its anti-drip effect can be disturbed by the gas occurred from calcareous fertilizer & livestock shit based fertilizer.

Anti-drip effect could be gone earlier if mulching film is not covered on soil and too much humidity was created by water screen in greenhouse.

If the greenhouse has winkles by improper covering, the anti-drip effect may not be advantaged.

(Caution) How to enhance the anti-drip effect

The gradient angle of greenhouse roof should exceed more than 25degree for easy water sliding when house frames are installed.

Double or triple layer greenhouse has better ant-drip effect rather single layer one.

Anti-drip effect is increased if the films produced 3 to 4months ago are applied to greenhouse.

Too much humidity in the greenhouse must be avoided by blocking unnecessary moisture.

Store at cool and dry place where no intensive heat or sunlight are.

(Caution) Anti-drip effect on the films is not guaranteed always.

The period of anti-drip effect can be varied greatly according to climate condition, humidity in the greenhouse, mulching film, farming method, local terrain, and plant characteristics. Please note that anti-drip effect is not guaranteed always.

Immediate film replacement must be taken to avoid the crop loss if of the anti-drip effect of the film is decreased.
The greenhouse film is not single factor affecting the crop loss and full responsibility on the crop loss is not provided.

(Caution) Anti-fog effect on the films is not guaranteed always.

What is Anti-fog? It means less fog or prevention of fog formation compared to ordinary film. The period of anti-fog effect is 50 to 75days (based on 0.06mm thick) depending on installation condition.

(Caution) User guide of the anti-fog film

Rapid increase in temperature inside of greenhouse could be occurred by high light transmittance. Proper control on greenhouse temperature is required always.

Low humidity in the greenhouse could feel cool at the same temperature. The plant leaf growth is small and possible to have powdery mildew

(Caution) How to increase anti-fog effect

Anti-fog effect can be starting slowly at the beginning of greenhouse installation when the soil turn-over job was done. Proper humidity control is carefully required at this period.

If the temperature fluctuation in the greenhouse is high at sunrise or sunset, temporary fog could be formed. Refreshing air and heating devices are required by proper controls on humidity and temperature to remove fogging.

If the humid air in the greenhouse is maintained for a long time, the ant-fog effect is getting deteriorated. Proper ventilation control is required to prolong the anti-fog effect. Make sure do mulching on soil to prevent moisture evaporation. Anti-fog film must be used for both inner & out layer film to ensure its effect.

If out layer film is not replaced and only inner layer film is replaced by anti-fog film, its performance is reduced or not speedy enough.

(Caution) Anti-fog effect is not guaranteed always.

Fogging is a natural phenomenon caused by the temperature difference inside and outside of the greenhouse. Proper humidity control inside of greenhouse is required. The period of anti-fog effect can be varied greatly according to climate condition, humidity in the greenhouse, mulching film, farming method, local terrain, and plant characteristics. Please note that anti-drip effect is not guaranteed always.

Immediate film replacement must be taken to avoid the crop loss if of the anti-fog effect of the film is decreased. The greenhouse film is not single factor affecting the crop loss and full responsibility on the crop loss is not provided.

The life span of the product varies significantly due to local environment and method of farming.
Please take caution of the points listed below.

The film weatherability could be shortening by inappropriate materials like Aluminum, steel plate, rusted metal, and PVC pipe.

Improper material, sulfur, fumigation, sulfur base or chloride base agents, affect the shortening the life span.

The life span of the film could be shortened or oxidized by the pesticide (Calcareous Bordeaux mixture) sprayed from neighbor greenhouse.

Sulfur and dust created by fuel heater using Diesel & Bunker oil could cause early oxidation and heat oxidation.

(Caution) Precautions when handling the products

Make sure to check the specifications like item & size are correct. Please, contact your local agent if is wrong.

Do not hold the strings on the package bands when carrying them. The strings on the package bands could be got cut off due to its heavy weight, and the heavy box falling into you causes injure or fracture.

(Caution) Right selection and use of TAJO® films

There are many product ranges of TAJO® films. The right selection referred from product catalogue is necessary depending on kinds of crop, types of harvest, and method of farming.

Do not use TAJO® films for other purposes as to food packaging.

(Caution) Cautions when spraying pesticides and working in the greenhouse

The life span of the film becomes shortened significantly when the pesticide is contact with the films directly.

Take a rest immediately if any headache or dizziness is occurred by long hour working. Take a caution on fires caused by flammable substance and electricity.

(Caution) Precautions for incineration

As the film (plastic) is a chemical substance, do not incinerate them by yourself to prevent air pollution and potential risk of fire
Please, recycle it through professional plastic collectors authorized by the recycling centre. ※Definition of ‘warning’ and ‘caution’

Warning: Danger can occur when used inappropriately which can result in death or serious injury to the user.

Caution: Small injury or material loss can be occurred due to inappropriate use or handling.

(Caution) precaution on the biodegradable film

Biodegradability of the film can be varied by soil condition, climate and amount of sunshine.

The biodegradable film has 1month shelf life only. Do not use leftover film.

Store in cool and dry place always (High humidity and temperature could initiate biodegradable activity before using.)

Rotary work is recommended after harvest. The remaining film in the soil will be biodegradable.

Biodegraded film does not affect the plant growth and crop yield.

This biodegradable film is limited at irrigation, greenhouse, and low tunnel where early biodegrading can be occurred.

(Caution) User Guide for TAJO® COATING greenhouse film

The greenhouse film should not be scratched by dragging to the ground or rusted pipe. The coating surface could be damaged, and it will lead film tearing and inferior performance on anti-drip effect.

Ceiling angle should exceed 25degree for smooth water sliding.
(Water forming and dropping is occurred if the ceiling is curved with small angle.)

Proper installation must be done without winkles.

Some water forming and dropping at early installation. But after sufficient moisture is supplied in 1-2 months, the coating layer becomes stabilized and activates anti-drip effect in the greenhouse.

When installing film on the greenhouse, more than 2 people must carry and not drag the film on the ground. Spread the film alongside the greenhouse and make sure the film faces correct way according to the user guide.

When the film is seamed, the anti-drip effect is deteriorated on this part. The seamed area should be concerned and placed properly when installing in the greenhouse.p>

Do not use this film as inner layer. Its performance is not guaranteed.

TAJO® coating must be applied as only out layer film at greenhouse. Do not use it for inner layer and water screen greenhouse in the case of double layer greenhouse.

Do not use it with the resin coated pipe or structure. Its resin coating may be stick to the film side.

When the sterilizing soil at high temperature, the coating layer on the film can be weaken.